Awesome concrete coating and brake caliper paint online shopping? The secret lies in POR-15 Rust Preventive Coating’s curing process. Most paints dry through evaporation, but POR-15 Rust Preventive Coating dries faster when moisture is present. It has the opposite chemistry of ordinary paints. Now add to that POR-15 Rust Preventive Coating incredible hardness, toughness, and flexibility and you have a coating that is practically indestructible. POR-15 Rust Preventive Coating is a permanent rust repair great for auto frame and chassis restoration, protecting valuable equipment against rust and corrosion. Use POR-15 Cleaner Degreaser and POR-15 Metal Prep to properly get your surface ready for the POR-15 Rust Preventive Coating. You’ll be amazed at the toughness!
A special fiberglass reinforcing fabric that can be used with POR-15 Rust Preventive paint to bridge gaps and repair holes in sheet metal. Handling Instructions: Do not handle fabric with bare hands. Because it is a special type of fiberglass cloth, the fibers may pierce your skin and you will experience discomfort. Wear a pair of gloves (or other protection) whenever you handle this cloth. As you cut the cloth, some fibers may fly into the air, so be sure to wear the mask provided while cutting. Please note that there is one large piece of cloth in this envelope.
POR-15 Rust Remover will safely remove light to even heavy rust completely from metal surfaces and will not affect plastic, PVC, Viton, or most paints. One gallon derusts several hundred pounds of heavily rusted steel, this equates to around 1/2 to 3/4 pounds of dry rust removed per gallon. Rust Remover will not harm unrusted steel and is safe on other metals. Rust Remover has no fumes or bad odors and no VOCs. No sanding or scrubbing required. POR-15 Rust Remover works in as little as 20 minutes for light rust or overnight for heavy rusted metal. All of the rusted areas must be submerged in the Rust Remover for it to work. When all of the rust has been removed, rinse the metal pieces with water. POR-15 Rust Remover works in as little as 20 minutes for light rust or overnight for heavy rusted metal. For best results use POR-15 Cleaner Degreaser to clean parts before using POR-15 Rust Remover. See extra information on rust remover.
When the POR-15 Rust Preventive Coating is just dry to the touch, with slight finger-drag remaining, normally in the 2-5 hour range, it’s ready for the POR-15 Caliper Paint to be applied. Open the can of POR-15 Caliper Paint, stir thoroughly, and apply the first coat in thin but even strokes. When the first coat is dry (3 -4 hours), apply a second coat to achieve a beautiful ceramic-like finish. These products should only be handled when wearing latex gloves, eye protection, and NOSHA approved respirator. Always work in a well ventilated area.
Rust conversion products claim to change the chemical nature of rust and convert it to a more stable element that won’t rust again. History of the failure of these products is well documented; most simply don’t work for more than a few months at best, and they are subject to the same chipping and cracking that occurs with ordinary rust coatings. POR-15 works because it chemically bonds to rusted metal and forms a rock- hard, non-porous coating that won’t crack, chip, or peel. It keeps moisture away from metal with a coating that is strengthened by continued exposure to moisture. Read more details on https://por15.com/.