Best splash resistance tester manufacturer? GESTER is professionally engaged in manufacture and R&D of Textile Testing Equipment with 20+ years experience, including Fabrics tests, Yarn& Fibre tests, Color fastness tests, Flammability tests etc. Various in styles, GESTER instruments’s textile testing equipment can meet the needs of different customers.GESTER insists on the use of high-quality materials and advanced technology to manufacture textile testing instruments. Besides, we strictly monitor and control the quality and cost in each production process. All this guarantees the product to have high quality and favorable price.GESTER serves every customer with the standards of high efficiency, good quality, and rapid response. Find even more info on splash resistance tester.
The AC servo drive system with low noise and wide range of applications. Pneumatic Bursting Strength Tester Test Methods: Constant Time Bursting. The tester bring saving and printing functions and support on-line operation. Provide on-line interfaces, professional detection software which can be used to analysis testing result. Summary of Test Method: A specimen is clamped over an expandable diaphragm. The diaphragm is expanded by fluid pressure to the point of specimen rupture. The difference between the total pressure required to rupture the specimen and the pressure required to inflate the diaphragm is reported as the bursting strength.
Correct use of computerized universal testing machine: When the electronic stepless speed regulation adjusts the lifting speed, it cannot be operated too fast. Before using the 50KN power machine, pay attention to check the tightening of the clamp tightening screws. When lifting the lower clamp, the movement should be stable, avoid collision, and often check the tightness of the clamp screw. When replacing the test fixture, pay attention to cooperate to prevent bruises.
ASTM D4060 Taber Abrasion Tester Uses and Factors to Be Considered: Taber Abrasion is used for measuring the wear resistance of organic coatings applied flat, rigid test samples. ASTM D1044 is used for transparent plastic materials to evaluate their capacity to maintain their optical properties, upon typical, wear to be expected while in service. Abrasion resistance to Taber Abrasion is usually measured as a weight or a coating thickness loss after a given number of cycles. Each arm, by default, is loaded to apply a 250 g. pressure on each wheel. Depending on the product/specification used, this weight can be increased to 500g or 1000g. The abrading wheels are available in different grit for a more or less abrasive action.
Reagent Preparation: Prepare corresponding reagents according to different test standards and keep them as standby. If sodium perborate is required in the test, the preheating temperature shall not exceed 60℃ when preparing the solution, and it shall be used within 30 minutes at most to prevent the loss of oxidant. Solution Warm-up: Put the specified volume of solution and a specified number of steel balls into the stainless steel cup, put the stainless steel cup into the launderometer for a few minutes, preheat to the specified temperature. Then put in the prepared sample for test. Read additional details at https://www.gesterinstruments.com/.